Keep that brick color rich and the joints full
Brick Paver Sealing in Jacksonville, FL
Call (904) 474-3568 to ask a Jacksonville contractor about sealing your brick pavers for free.
- Brings out deeper paver color
- Fresh joint sand helps lock pavers in place
- Gives weeds less room to grow
- Makes the surface easier to keep clean
- Free estimate, no obligation
Request a Free Estimate
Free, no obligation.
Who seals brick pavers around Jacksonville, and when will they call back?
A local contractor seals brick pavers in Jacksonville, FL, and your message gets an answer within 1 business day, usually much sooner. The visit is free, with no obligation. To get a person on the line now, call (904) 474-3568.
Brick pavers are a long-lived surface, and Paver Protections says they can last for decades when installed properly. What wears out first is the color and the sand between them. A coat keeps the red warm, holds the joints in place and gives algae less to grip. Describe your walk, drive or patio, and ask for your free estimate.
Why do brick pavers fade and chalk in the Florida sun?
Why Jacksonville brick color slips
Sun and water wear the surface down. Jax Exterior Cleaning says an unsealed top layer breaks down, small white stones show through and the sun fades the color, and Wikipedia puts a July day in Jacksonville near 92 degrees. Spots beside the garage or the front steps tend to go first. Point out the faded patch when you ask for your free estimate.
What sealing can and cannot restore
Stallone's Pro Wash makes a similar point, saying strong sun can fade unsealed pavers within a few summers. Sealing does not bring back lost pigment, but it keeps the color you have from slipping further. For a look at your bricks, ring (904) 474-3568.
Is it safe to pressure wash brick pavers before sealing?
Pressure limits for Jacksonville brick
It is safe with limits. Western Interlock says to keep a surface cleaner at about 1,500 PSI or less and keep a wand at least 6 inches from the surface, because washing can disturb joint sand. A pattern like herringbone has a lot of seams, so a hard blast empties them quickly. Ask what pressure the contractor uses when you ask for your free estimate.
Pretreatment before force
Jax Exterior Cleaning pretreats mold, mildew and algae with a soft wash, then follows with surface cleaning. That order lets the chemistry loosen growth so force does less. If you have a favorite way to clean and want it checked, call (904) 474-3568.
Should I choose wet look or natural matte for brick pavers?
Wet look or natural matte in Jacksonville
That is a matter of taste and rules. Wet look deepens the red and brown, while Stallone's Pro Wash lists natural matte among its four finishes for a look near the unsealed color. Older neighborhoods and HOAs sometimes prefer the quiet look. Ask to see both on a small test patch and ask for your free estimate.
Traction on steps and walks
Traction counts on steps and walks. Paver Protections calls brick slip-resistant, but a smooth glossy film can change that when the surface is wet. Coastal Outdoor Construction, a Jacksonville contractor, warns against smooth high gloss sealers on pool decks for this reason. Mention steps when you ring (904) 474-3568.
Does brick need the same sealer as concrete pavers?
Matching the sealer to the brick
Not always. The sealer maker's data sheet decides, so ask which product the contractor plans to use and whether it suits your brick. Unilock says a sealer should be breathable so moisture can escape, and that sealing over trapped moisture can leave a whitish film. Ask for the product name in writing when you ask for your free estimate.
Do brick pavers near Jacksonville oaks or a pool need extra care?
Tannin and shade in Jacksonville
They can. Safe Touch says live oaks leave brown tannin stains and that shady Jacksonville lots keep mildewing through winter, and a brick walk under a tree catches both. Light brick shows the tannin more, and deep red hides it. Mention your trees when you ask for your free estimate.
Chlorine and splash near a Jacksonville pool
Pools add chlorine and splash. Safe Touch lists pool chlorine, full sun and storm washout as reasons a coat in Jacksonville wears down near the two year mark, and Coastal Outdoor Construction says a smooth gloss sealer is the usual reason a wet deck turns slippery. Brick by a pool needs a calm sheen. To plan yours, call (904) 474-3568.
What is the brick paver sealing process in Jacksonville?
What the published Jacksonville rates say
The order follows what Jax Exterior Cleaning, Western Interlock and Unilock describe. Brick joints are many and narrow, so each step protects them. To have the order explained for your walk, call (904) 474-3568.
1. Inspect the brick
The contractor looks for loose bricks, low spots, old sealer and stains, and notes the pattern and borders.
2. Pretreat and wash
A soft wash lifts mold, mildew and algae, then a surface cleaner works at about 1,500 PSI or less.
3. Dry and re-sand
Once the brick is dry, sand is swept into every seam, activated and brought to the right height.
4. Seal in a thin coat
A low pressure sprayer or roller lays the coat and a back roll evens it. Unilock advises no more than two layers.
5. Cure and walk it
Feet and furniture stay off for the cure time, which Unilock puts at 24 to 48 hours.
What do brick pavers cost to seal in Jacksonville?
Patterns, cuts and borders
Safe Touch, a Jacksonville company, publishes $1.75 to $3.25 per square foot for a clean, sand and seal, with stripping a failed coat extra. Stallone's Pro Wash posts $0.22 per square foot as its cleaning start and $1.90 as its sealing start. No Jacksonville page read for this site gives a separate rate for brick, so the table below builds one from those published pieces. To price your brick, ask for your free estimate.
Replacing a single brick in Jacksonville
Patterns with many cuts, curves and borders take longer to wash and sand, and Gravity Wave names joint condition and existing coatings among the price factors. Ask whether your pattern changes the quote. Want a number for it? Call (904) 474-3568.
| Brick area | Typical example | Cleaning only, from | Sealing only, from | Clean, sand and seal |
|---|---|---|---|---|
| 300 sq ft | Front walk and stoop | $66 | $570 | $525 to $975 |
| 500 sq ft | Brick patio | $110 | $950 | $875 to $1,625 |
| 900 sq ft | Brick drive with a border | $198 | $1,710 | $1,575 to $2,925 |
The third and fourth columns multiply the $0.22 and $1.90 per square foot starting rates Stallone's Pro Wash lists. The last column multiplies the $1.75 to $3.25 range Safe Touch published, read in November 2026. The sealing-only column assumes clean, filled joints. A contractor sets the final price after a look.
Can one broken brick paver be swapped without redoing the walk?
Reseal timing for Jacksonville brick
Often yes. Paver Protections says brick pavers can be repaired individually, and Stallone's Pro Wash notes that matching an older or unusual paver can be difficult. Keep any spare bricks from the original install in the garage. Repair comes before sealing, since a coat over a loose brick locks in the problem. Have a wobbly brick? Ring (904) 474-3568.
How often should brick pavers be resealed in Jacksonville?
Older walks and courtyards in Jacksonville
Two to three years is the interval Safe Touch and Jax Exterior Cleaning give, and Stallone's Pro Wash allows two to five in Northeast Florida. A south-facing brick drive sits near the short end, and a shaded side walk near the long end. PaverGuard, a Jacksonville company, suggests a few drops of water as a test: if they vanish at once, the coat is gone. Do the test, then ask for your free estimate.
Are older Jacksonville brick walks and courtyards any different?
Rules in historic and HOA areas of Jacksonville
They can be. Wikipedia says San Marco began its upscale growth in 1926 with many Mediterranean Revival homes, and nearly all of downtown burned in 1901, followed by a building boom, so many homes and walks in the older parts of town are decades past their install date. Old walks can settle, and the sand beneath them can move. Ask the contractor to check levels and joints when you ask for your free estimate.
A historic district or an HOA may also have rules for visible work. If you live under review rules, call (904) 474-3568 and ask whether the contractor has handled a similar request.
What do sealed brick paver walks look like in Jacksonville?
Which Jacksonville neighborhoods can get a brick paver estimate?
Each place below has a page of local notes, and brick pavers anywhere on the list can be priced for free. Not sure about your street? Ring (904) 474-3568.
What do Jacksonville homeowners ask about brick paver sealing?
Is it good to seal pavers in Florida?
Usually, once brick pavers show fading, sand loss or green growth. Jax Exterior Cleaning says an unsealed surface breaks down, small white stones show and the sun fades the color. A brick-red walk that looks pale and chalky is worth a closer look.
Can I pressure wash brick pavers?
Yes, with limits. Western Interlock says to keep a surface cleaner at about 1,500 PSI or less and warns that washing can disturb joint sand. Brick pavers have many small joints, so a blast that cleans the face can empty the seams. Plan on fresh sand after any wash.
Do you seal pavers before or after polymeric sand?
After. Unilock says the sand goes in first, is activated, and only then does the sealer follow once the surface is dry. Brick patterns such as herringbone have a lot of joint length, so skipping this order leaves a lot of loose sand under the film.
How long do paver sealers last?
Safe Touch calls two to three years typical in Jacksonville, and Stallone's Pro Wash allows two to five years in Northeast Florida. Paver Protections says brick pavers can last for decades when installed properly, so the pavers outlive many coats. Sealing is the upkeep, not the lifespan.
Will a wet look sealer change the color of my brick pavers?
Yes. Jax Exterior Cleaning describes its two-part water-based sealer as one that enhances color and gives a wet-look shine, and Stallone's Pro Wash lists natural matte as a separate finish. If you like the aged color you have, ask for natural matte and test a small spot first.
Can brick pavers be fixed one at a time?
Yes. Paver Protections says brick pavers are repairable individually, and Stallone's Pro Wash says older or unusual pavers can be hard to match. That is why spare pavers from the original install are worth keeping.
What does it cost to seal brick pavers in Jacksonville?
Safe Touch publishes $1.75 to $3.25 per square foot for a clean, sand and seal. Stripping failed sealer costs more. Gravity Wave says price follows area, condition, access, existing coatings, joint condition and finish, so a patterned brick walk with many cuts can price above a plain slab.
Which other paver services might my brick surfaces need?
Brick walks and drives often need a stain treatment or a repair before a coat goes on. Each service has its own page. To talk through the order of work, call (904) 474-3568.
Ready to protect your brick pavers?
Tap the form or dial, and someone answers within 1 business day, usually much sooner.
Free, no obligation